Overview
If the video software on your Gateway Appliance stops responding, you can restart it remotely, or reboot the whole appliance, from the Gateway's Web Diagnostics page. Use this when live video is frozen or cameras are connected but show no video.
Note: Neither action deletes anything. Recorded video, camera configuration and settings are untouched. The only footage lost is from the period while the system restarts.
Requirements
An Arcules user with both the IT Manager and Remote Device Access (Unrestricted) roles. Together these show the Gateway's Offline Access tab and its Remote Device Access link.
The Gateway must be online. Without an internet connection it cannot be reached remotely.
The Two Actions
| Restart VMS application | Reboot Gateway |
What restarts | The video software only | The whole appliance |
Downtime | About 30 to 60 seconds | Several minutes |
Recording | Pauses, then resumes | Stops, then resumes |
Other Gateway functions | Keep running | All stop |
Always try Restart VMS application first. Reboot only if the restart did not fix the problem.
Warning: Both actions interrupt recording. Avoid running them while the site is busy, footage is being exported, or an incident needs continuous recording.
How to restart the VMS or reboot the Gateway
Open the Gateway. In the Web Portal, open the Gateway's device drawer.
The Gateways list with the device drawer open
Gateway drawer, Overview tab
Get the device token. Open the Offline Access tab and note the six-digit token. It changes every 30 seconds, so keep the tab open.
Offline Access tab, before retrieving the token
Offline Access tab with the current device token and its expiry countdown
Open Web Diagnostics. Select the Remote Device Access link in the device drawer. The Gateway's Web Diagnostics page opens.
Select Remote next to the IP address
Connection Established confirmation
Choose the action. In the Device actions card, select Restart VMS application or Reboot gateway. Hover over a button to see its impact.
Device actions card on the Web Diagnostics page
Confirm. Type the Gateway's name exactly as shown, give a short reason (for example "Live views frozen on all cameras since 14:20"), and enter the current device token. Then select the action button. The confirmation expires after 90 seconds.
Reboot gateway dialog, before filling in the fields
Reboot gateway dialog, ready to confirm
Wait for it to finish. The card shows Cooldown and the result under Last action. After a reboot, the page is unavailable until the Gateway is back.
Note: Each device token works once, and five wrong token in five minutes locks the actions for fifteen minutes. After a successful action, both buttons are unavailable for ten minutes.
Afterwards
Check live video. Every camera should come back.
Check the Gateway is online in the portal.
Check the original problem is gone. If a VMS Application restart did not help, try a gateway reboot, or contact Arcules Customer Care.
A gap in recordings covering the restart is expected.
Record of actions
The Gateway keeps its own record of every action: what ran, when, the result, and the reason given. The most recent action and its reason are shown under Last action on the Web Diagnostics page. Arcules Customer Care can retrieve the full history from the Gateway if needed.
When these actions help
They help when the video software is stuck: frozen live views, cameras that are connected but show no video, or playback that will not load. They do not fix a faulty camera, a bad cable, or a lost internet connection.
If the Device actions card does not appear, the feature has not been enabled on your Gateway, or the page was opened directly on your network instead of through Remote Device Access. Contact Arcules Customer Care.









